Solomani666
Mongoose
Is this the correct procedure for prospecting:
1. Pilot check for orbit
2. Roll Electronics (Sensors) to determine if a rock has potential.
3. Scan for the number of shifts indicated on the size table for a full survey.
4. Roll Electronics (Sensors) again and if successful. <----- ??
5. Consult the Scan Potential table and the Composition table.
6. Roll the target number of the Resource Presence table.
7. If successful then check the Yield table for the amount of the find.
8. Stake claim etc.......
Where does the Profession (Belter) skill come into play?
1. Pilot check for orbit
2. Roll Electronics (Sensors) to determine if a rock has potential.
3. Scan for the number of shifts indicated on the size table for a full survey.
4. Roll Electronics (Sensors) again and if successful. <----- ??
5. Consult the Scan Potential table and the Composition table.
6. Roll the target number of the Resource Presence table.
7. If successful then check the Yield table for the amount of the find.
8. Stake claim etc.......
Where does the Profession (Belter) skill come into play?