Creating a Breakaway Hull

Discuss the Traveller RPG and its many settings
phavoc
Cosmic Mongoose
Posts: 4877
Joined: Tue Nov 04, 2008 6:13 pm

Re: Creating a Breakaway Hull

Postby phavoc » Sun Jan 26, 2020 8:49 pm

Condottiere wrote:
Sun Jan 26, 2020 1:54 pm
Most captains probably want visitors to be docked at designated spots on their hull, and not be like barnacles, which is why they are the clampor.

Having multiple clamps means more care in lining up the two hulls; release should be almost instantaneous.
Unless you want them walking along your hull to the nearest airlock, I think it's safe to assume that visitors (as opposed to boarders) will always dock at designated spots. :)

Depends on how you design your multiple clamps for the potential for added complexity. More clamps also means more safety (a single failure of a single clamp also means your docked ship will no longer be docked).
Condottiere
Warlord Mongoose
Posts: 7850
Joined: Mon Sep 23, 2013 8:23 pm

Re: Creating a Breakaway Hull

Postby Condottiere » Mon Jan 27, 2020 7:02 am

I don't doubt that.

Though I suspect it also has to do with any undue stress applied, like acceleration, though I couldn't tell you at what point the clamps would just rip off, if not crack.
snrdg121408
Greater Spotted Mongoose
Posts: 1127
Joined: Mon Dec 15, 2008 3:17 am
Location: Roy, WA USA

Re: Creating a Breakaway Hull

Postby snrdg121408 » Mon Jan 27, 2020 1:31 pm

Hello phavoc and Condottiere,

Thank you both for the replies and my use of multiple docking clamps of the same type rather that a single clamp is based on my USN experience were all the equipment had more than one fastener holding them in place. Being in SONAR doors on the equipment usually had at least double the number of fasteners to hold them closed. Having to undo all of the fasteners for maintenance or repairs was a pain in the behind, especially when there was a need to do the job quickly.
snrdg121408 (aka Tom R)

Who is online

Users browsing this forum: No registered users and 13 guests